Grinding coal dusting machine installation of check:
Coal powder machine installation, contact mill duster traces best under no load condition, is usually satisfactory, because the ball (
The load caused by the misalignment of the meter is only a few millimeters. However, in the case of loading, in the 3 or 2 teeth on the final
Positive check of.
Contact traces are concentrated in the center of the gear teeth, which indicates that the gears are correctly. Generally speaking, there is no visible trace of the initial load.
Tooth width should be more than 50%, on the tooth length should be more than 40%. It is important to know that it is very difficult to find a complete uniform contact trace, because of the geometric essence
The degree and the surface cleanliness are not perfect, in the no load condition will affect the contact marks, resulting in a certain degree of incomplete contact traces
.
In the equipment to achieve full load, should as soon as possible to use flash frequency inspection method and inspection results of tooth surface scraping and grinding coal powder machine to identify traces
Well recognized positive state. If the flange end face runout within a specified tolerance, the large gear contact marks a week should be quite stable, but
It is necessary to keep the contact trace on average when there is an obvious beat.
Coal grinding powder spraying machine is to solve the low thermal efficiency, high energy consumption and backward production technology, serious environmental pollution of the new technology and method, and transmission
Compared with the traditional technology, energy saving up to 30-70%, and can improve the output of the stage. The set of equipment for crushing and grinding, burning powder as a whole, the quantity of coal
Can be arbitrarily adjusted, and can achieve unmanned automation