A brief introduction of BLS-, -8L type wet kiln dust collector in Twin Towers:
According to the existing in the use of several wet dedusting problems, I plant leadership and technical department after repeated investigation, studied and absorbed many water dust collecting the advantages as a whole, and used a lot of original technology. The successful development of a set of various sintering methods, adapt to a variety of adverse conditions, and to overcome the the water dust collector and other water dust can not overcome the difficulties, namely BLS-II-8L type double cone tower low resistance efficient wet dust collector and KFX-I type rapid mud water separator characteristic of the system is the biggest:
1, BLS- type II -8L Twin Towers wet duster adopts double cone tower shaft kiln dust, the water does not contact the cylinder wall, to prevent clogging caused by sticky ash.
2, BLS- type II -8L wet kiln dust sprinkler head for Twin Towers installed in the area outside of the dust and dust, not to solve the problem of contact nozzle, nozzle clogging due to spray out of water absorbing effect.
3, BLS- type II -8L wet kiln dust collector of the Twin Towers Twin Towers is directly mounted on the two shaft kiln chimney, flue gas to avoid detours caused by walking resistance, so the equipment resistance is very low, no need not produce anti smoke phenomenon induced by wind.
4, BLS- type II -8L Twin Towers wet precipitator using water kiln dust, to accelerate water circulation, so that the water temperature is low, can solve the pipe scale, water evaporation is reduced, and the dust removal effect is not good phenomenon.
5, BLS- type II -8L wet kiln dust collector Twin Towers all use of recycled water, not to waste water discharge and kiln.
6, dust discharge of sewage through the mud mud and water separator will be quickly separated. The separated by a row of mud porridge paste to biaxial mixer, and without any mud mud equipment. 100% recovery and use, no row to the ground and made two times pollution yang.
7, low operating cost of equipment, power consumption is only 9KW.
8, less investment, low investment compared with similar products 100 thousand yuan / Taiwan. Therefore, the water dust remover of the technology to a large extent are superior to existing in various forms, and to ensure the effect of dust. The fire kiln dust emission concentration is less than 150mg/m3, the fire kiln does not exceed 100mg/m3.
Two, BLS- type II -8L wet kiln dust catcher performance of Twin Towers:
1, the processing capacity of 30000-60000m3/h;
2, allow the dust concentration of 50mg/m3;
3, sewage treatment capacity 20m3/h;
4, more than 99.6% of the dust removal efficiency, dust emission concentration is lower than the national standard of the implementation of the two categories;
5, water consumption 0.2m3/h;
6, the power consumption of 9KW, when the wind is required to induce 31KW;
7, the discharge of water content of 50%;
8, after treatment, sulfur dioxide can be removed more than 50%;
9, recycling water utilization rate of 100%;
10, the recovery of material utilization rate of 100%;
11, equipment investment of 40-45 million / sets