Composition of dust remover for conveyer belt conveyor:
The dust collector of the conveying belt conveyor is composed of an upper box body, a middle box body and a pulse ash cleaning system. In the main system under the action of the fan, the chamber gas containing dust from the air inlet into the lower part of the dust remover with machine and then into the bottom of the dust collector were pretreatment gas containing dust, and then from the bottom into the box on the indoor dust; dust adsorption on the outer surface of the filter cartridge, a clean air filter after the gas canister into the cavity through the net on the box and collected to the outlet discharge.
With the continuous accumulation in the bag filter condition, on the outer surface of the dust will accumulate, the corresponding will increase the operation resistance of equipment, in order to ensure the normal operation of the system, must carry on the filter cylinder cleaning regeneration, by special pulse automatic controller through constant resistance or timing command, three state ash. Generally, the long-term stability of the bag filter is about 99.7%, and the dust removal efficiency of the belt conveyor can be as high as 99.9%.
Structural characteristics of dust collector for conveyor belt conveyor:
The basic structure of this series of dust collector is composed of three parts: fan, box and ash door. Each component is installed in a vertical frame. The structure is very compact:
1, fan parts using universal standard, easy to repair and replacement, and the use of isolation facilities, noise.
2, material selection is 729 cylinder bag, good filtering effect, long service life.
3, the cleaning mechanism is the use of motor driven linkage mechanism, so that the bag and the bag inside the surface clearing method of jitter, the control device control or control two break up. The length of the ash cleaning time is adjusted by the user to adjust the time relay. (electronic control box, the user with the filter set to order),
4, the ash door uses the two kinds of structures of the door and the ash door, the dust is very convenient.
The dust laden gas into the box from the dust remover entrance, filtered through the filter bag, dust bag was left on the inner surface of the purified gas into the blower through the filter bag, sucked by the blower fan directly into the interior (also can take over into the outdoor)