Mutton is rich in calcium, iron, zinc, selenium, vitamins, protein and other nutrients, and its fat content is very few. Chinese medicine believes that mutton can make blood, tonifying deficiency, kidney yang, nourishing spleen and temperature, etc.. When the weather is cold, a bowl of warm mutton soup will make you feel satisfied. But the traditional big pot boiling is easy to cause the environment messy, and the labor force is big, how can that improve this situation? This is the use of a sandwich pan.
Cautions for the use of gas-fired intercalation cooker
1, gas intercalation pot in the production of the working site, to have a certain ventilation facilities to maintain a good ventilation environment.
2, before each production, the gas pipeline and valve should be checked to prevent gas leakage, causing gas poisoning or fire accidents.
3, check the seal of each joint at regular intervals. Keep the stove clean, prevent the production of the material to drop the stove hole blocking plug.
4. Turn off the gas when the material is leaning and turn off the speed control switch.
5, the burner can only use liquefied gas and natural gas to remember that all other gases are not to be used.
6, in the production process, we must ensure that the gas pressure is within the normal range. If it is not in the normal range, it will cause insufficient combustion gas, which will increase the possibility of gas poisoning.
7, the pipe and valve connecting the stove will be screwed to the dead surface naturally and keep a safe distance, so as to avoid the accident caused by my scorching.
8. Do not place articles around the gas intercalation pan so as not to cause a fire.
9, after the end of the work, the gas valve and the front switch must be closed and tightened to prevent the accident.
10, tilting and stirring the pot sandwich, no boot should be used in various rotating parts grease. A part on the body of a stirred sandwich pan.
11, clean up the domestic and join the material. The heat transfer oil is added to the power supply. When the material reaches the required temperature and the heating time is reserved, turn off the power supply. Turning to the handwheel will tilt the pot into the discharge.
12. The PT100, a temperature sensor behind the pot, is used to measure the temperature of the heat conduction oil. The set temperature is measured by the electronic control box and will not continue to be heated when the set temperature is exceeded. It will continue to be heated when it is below the set temperature.
13. In the process of operation, the temperature should be strictly controlled. Under the general condition, the temperature control should be used below 200 degrees.