Environment-friendly rosin pot stainless steel rosin pan to the gross Nuo rosin pot has the advantages of large heating area, high thermal efficiency, fast heating, uniform heating and easy to control the heat and temperature. It can quickly and effectively melt the rosin in the pot, delay the carbonization of rosin and save electricity. At the same time, it not only ensures the service life of the heating tube, but also saves the rosin. Let you save costs while also increasing the product's ability to work.
Function:
1, heating by electric heating tube, passing through the heat conducting oil to the boiler body, and the heat efficiency is high.
2, the insulation layer is aluminum silicate insulation, good heat preservation effect, not hot.
3. The temperature controller is fully digital display, convenient operation, accurate control and automatic control.
4, the use of leakage protection switch, operation safety.
5. It has a variety of models and can be chosen.
Application and operation:
1, before filling in the use of the first 320 heat conduction oil, generally one-time filling 130kg~150kg, filling the oil level with vernier as the standard.
2, when refueling, the hole three pipe should be screwed down and the dipstick hole should be screwed open for exhaust.
3, when the oil arrives at the oil level, let it stop for 10 minutes before heating.
4, heating first close the leakage switch in the distribution box, pull the power switch on the distribution box door to the open position. At this time, the temperature controller has electricity, and it can set the number first.
5. When setting the temperature controller, press the SET button first. When the number is flashing, it can be increased or reduced according to the weight of the device.
6, add rosin, general rosin into the rosin pot 4/5.
7, heating, pull the heating switch on the panel of the distribution box to the direction of heating, and point to the right upper part. At this time, the heating lamp is green and the heating starts to work.
Matters needing attention：
1. Vent holes on the top of the rosin pot must be kept open and blocked, so as to prevent serious consequences.
2, to choose the right power line, generally a group of heating copper wire 10 square, two sets of heating wiring 16 square, GB line.
3, we must first add heat conduction oil and then start heating, do not dry burn, so as not to burn bad electric heating tube.
4, the temperature of the rosin pot is 160 degrees to 250 degrees.
5, if the blowhole is found out of white smoke, it is the carbonization of the heat conduction oil, the electric heating pipe is not out, the heating pipe temperature is too high, or the quality of the heat conduction oil is not good, the heating can not be continued at this time, and the electric heating tube should be treated as soon as possible.
6. Check the tightness of the screw of the wiring post regularly to maintain good contact and prevent the heat from burning the terminals and electrical appliances.
7, heat transfer oil must be replaced after one year, to prevent aging conjunctiva and affect heating effect.
8. When the rosin pot is used for half a year, it should also dismantle the heating flange, clean the impurities in the barrel and the oil on the heating pipe, so as to prolong the service life of the pine oil pot.