In order to study the new products, our company has produced an experimental sterilization pot, which can be sterilized by water bath, spraying and steam sterilization. The control mode is computer automatic, the heating mode is electric heating, and the power consumption is small. The source is easy to use. At present, Tianjin University, Harbin Academy of Agricultural Sciences, Qilu University of Technology, Jilin Agricultural University are using this sterilization pot, its sterilization methods are complete, to meet different products and different product packaging, if doing experiments, this sterilization pot is the first choice.
Automatic sterilizing pot, experimental sterilizing pot and spraying sterilizing pot are new products developed on the basis of double-deck water bath sterilizing pot. The advantages of this equipment are that the output of the double-deck sterilizing pot is increased by one time, the energy is saved, and the investment cost of the equipment can be greatly reduced by users. The high temperature and short time sterilization uses the Double pot hot water circulation to sterilize, the water in the sterilization pot is heated to the required temperature in advance, thus shortening the sterilization time and improving the work efficiency. The working medium used in the sterilization process can be recycled to save energy, time, manpower and material consumption, and reduce the production cost. During sterilization, two cans were used alternately as sterilizing tanks, and at the same time, the output was increased. The uniform flow exchange method has uniform temperature and no dead angle.
Automatic sterilizing pot, experimental sterilizing pot and spraying sterilizing pot adopt international advanced technology, and use hot water circulation and immersion sterilizing. During the sterilizing process, the circulating water in the sterilizing pot changes continuously from top to bottom, left to right, which ensures that the temperature in the sterilizing pot is raised, kept warm and cooled, and the heat distribution at any point is uniform and effective. The dead angle phenomenon in sterilization process is eliminated, and the shelf life of products is more stable and longer. The temperature in the sterilization tank kept stable during all stages of sterilization, and the qualified rate of F value was guaranteed. Chart flat panel, screen touch control, all the time are controlled by analog sensors and automatic valves, can be switched from a single sterilization process to multi-stage sterilization process. Pressure and temperature are displayed digitally, and various pressure and temperature modes suitable for any product can be programmed and input into a computer.