Now the sterilization pot on the market mainly has two kinds of materials: stainless steel and carbon steel. Some manufacturers use stainless steel 201 or 304 to save cost. The carbon steel sterilization pot uses Q235. Our company's sterilizers are made of high quality plates. Stainless steel sterilization pot body is made of 30408 stainless steel plate, which is pressure resistant plate and meets the requirements of national pressure vessel. Q345R is used for carbon steel, with compression plate and better corrosion resistance than Q235. Whether it is a carbon steel sterilization pot or a stainless steel sterilization pot, the stainless steel plate used for the matching car, tray and plate. Chongnuo series sterilizer is an indispensable equipment in food sterilization because of its low price and high cost performance.
There are five types of tank structure:
1. Single pot sterilizer
2. Double layer sterilizer Double pot parallel sterilizer three pot parallel sterilizer
3. Vertical sterilizer
4. Electric steam sterilizer
5. Rotary sterilizer
From the material of the pot body, there are:
1. All stainless steel
2. Carbon steel
Installation instructions
(1) installation foundation of equipment: the installation ground can be lowered appropriately as required to balance the rail car and height with the ground, so as to facilitate the cart to push into the pot.
(2) install the safety valve on the boiler as shown in the drawing. Before the equipment leaves the factory, it has been adjusted to the start-up pressure of 0.27MPa (hydraulic test pressure). The user can retest, but it is not allowed to raise the start-up pressure at will.
(3) if the superheated water heating medium is used, the cooling water supply pressure is 0.4 MPa ～ 0.5 MPa. In order to ensure sufficient water source and pipeline water supply pressure, users are requested to add a reservoir and a pressure pump by themselves. Check valve shall be installed at the water inlet pipe to prevent the water inlet valve from leaking into the water supply pipe when the steam pressure in the boiler is high, so as to make the water pump idle without water