Specification for welding fume purifier, dual arm welding fume purifier
Equipment advantage
1, can be flexibly moved in any position of the factory, not affected by dust points and positions are not fixed constraints.
2, equipped with casters, convenient positioning and mobile equipment.
3, the processing efficiency, the rated air volume, the dust removal rate is more than 99%, the clean air can be discharged after the treatment cycle emissions directly in the workshop.
4, imported from Germany (PTFE) coated filter material, high precision, high purification efficiency, low material cost, without frequent replacement, saving and environmental protection.
5, equipment built-in automatic pulse ash cleaning device, keep the equipment constant suction volume, and constant purification ability. (optional)
6, the special design of the control system safety and stability, with high-voltage leakage protection.
7, the use of flexible suction arm, can hover in any position in the three-dimensional space, 360 degrees easily reach any point of dust.
8, special conditions can be selected according to the site corresponding dust hood mouth.
9, the special shock absorption and noise reduction, to ensure the noise of the equipment environmental protection.
10, the equipment is simple, easy to clean maintenance.
11, the pollution source can be mobile stand-alone processing or multi station system centralized treatment.
12, according to customer special requirements R & D custom.
Working principle:
Through the action of the draught fan, the exhaust gas through the suction hood suction device welding equipment air inlet, an air inlet is provided with a flame arrester, smoke gas enters the sedimentation chamber by gravity and upward airflow, the coarse dust dust dust particles directly to the bucket, were collected on the outer surface of the filter, clean air into the clean room by filter the center is exhausted out from the air outlet.
Replacement and cleaning of the filter element through the differential gauge display