Kunming workpiece cutting table plasma cutting dust purification factory
parameter
Air volume: 2400/3000/6000 cubic meters / hour
Power: 2.2/3.0/3.0*2Kw
Voltage: 380/50 V/HZ
Filtration efficiency: 99.97%
Size: 1200*850*160/1500*850*1600/2000*850*1600mm
Working principle
Negative pressure dust produced by the blower through the side outlet and the lower air outlet enters the purifier, air flow into the diversion channel, large particles of dust and the plate after the collision, the gravity and inertial force is fallen into the dust collecting drawer, the dust laden gas into the filter chamber containing fine particles, clean air from the outer surface of the bag through the filter. The dust filter is blocked on the surface to be stopped when the dust in the filter surface when deposited by manual cleaning machine cleaning filter, but also by the pulse jet cartridge of ash, the deposition of dust particles in the filter on the out surface of the filter core is fallen into the dust collecting drawer, making the filter surface get clean, purified air from the air duct, the fan discharge.
Operating characteristics of dust collection unit:
1 cost: this method is in the traditional dust suction unit, reducing the exhaust pipe. Pipeline can be saved, wind cover production costs.
2 operation of the economy: due to the reduction of the wind pipe resistance, in the fan full pressure reduction, the power can be reduced by about 30%, can reduce the operating costs.
3 dust thoroughly: each unit effective air inlet area of about 3 square meters, an effective filtration area of 32 square meters, wind speed greater than 3 M / s. Single cycle air filtration efficiency can reach 0.5UM particles greater than 95%. The general design of the air circulation for the workshop volume of 10-20 times / hour.
4 reliable operation: has been used in the manufacture of glass fiber reinforced plastics and furniture factory, dust removal effect is very obvious, very satisfied with the customer. Can take the customer site visit.
5 workshop temperature: the unit uses the internal circulation way, to the indoor temperature has not changed, is advantageous in maintains the workshop winter heating temperature.
6 easy to install: the unit installation without foundation, the general can be placed on the wall, you can move