Full automatic cleaner
Product overview
Full automatic cleaner uncel brand by the filter body, a steering valve, filters, drain. The treated water enters into the filter body through the water inlet, impurities in the water will be retained in the stainless steel strainer when impurities accumulated to a certain extent, inside and outside the filter on both sides of the differential pressure reaches the set value (less than 0.05MPa), open the drain valve, close the steering valve, strainer to discharge.
Two, equipment characteristics
1 the filter can work normally under the full flow, continuous water, not only to maintain a high flow rate, but also has a low pressure drop, to avoid the low flow rate caused by surface stains;
2 directly installed in the pipe network system, do not need any support structure, save space;
3 easy to install, just access to the pipeline to be processed;
4 do not need to install bypass lines, removal of sewage;
5 cleaning does not affect the normal filtration.
Three, product features
The cleaner is used to remove impurities and dirt and filter in the pipeline, keep the water system in the clean, reduce resistance, protection equipment and to prevent pipe blockage. Four, equipment structure and working principle
The structure form of the dirt cleaner is divided into horizontal straight decontaminator, horizontal angle and vertical straight through the cleaner cleaner three forms according to the national standard R406. The cleaner is provided by the original standard filter in galvanized wire mesh for improved special stainless steel strainer. In the decontamination device, flow into the cylinder body from the water inlet through the filtering net flow of water by the water outlet, the dirt is deposited on the decontamination device at the bottom, after the sewage discharge.
Five, performance parameters
Caliber: DN50----1000 design pressure: 1.6Mpa
Design temperature: 200 diameter: diameter: 1-
Flange standard: JB/T81-94
Six, installation and use
The cleaner should be arranged in the entrance pressure regulating device of heating system or equipment in front of the entrance. Through the dust removal device installed in horizontal pipe, angle formula removal device can be installed in the pipeline turn on the shell is installed the arrow must be consistent with the direction of flow. Should be regularly discharged during operation