Oil sampler is also called negative pressure oil sampler, oil sampling device, oil sampler, etc.
The oil sampler can be used for the accurate analysis of the oil samples, especially when sampling, to prevent dust, impurities and the residual oil in the previous sampling mixed with oil samples.
Parameter description:
Use: all kinds of laboratories, oil refineries, petrochemical plants, oil sales companies, oil depots, oil tanks and gas stations
Material quality: Super duralium
Lattice gauge: no pollution hose and a negative pressure type oil pumping unit and one-time use (100ml, 250ml, 500ml, and other specifications optional) can effectively prevent oil adhesion to the oil and external contamination of oil rush.
Advantage description:
1, the use of light, no noise;
2, according to the actual requirements of the user to choose the appropriate cleaning bottles (NAS1638 standard)
3, the user can choose the size of the sampling bottle according to their own production capacity (clean bottle specification: 250ml)
Usage method:
1 round nut oil gun in front of the loose circle, the hose through the nut, then tighten the nut and the fixed joint oil gun and hose. (lower hose out oil gun joint 1-2cm to avoid oil gun joints and oil gun inside oil pollution)
2 the oil sample bottle is screwed to the oil gun joint.
3 the other end of the hose into the oil. Extend the hose into the oil depth of about 50mm. In this way, the hose will not be sucked into any sediment; if the hose is too long, can be cut into the appropriate length, in order to reduce oil absorption resistance and smooth pumping
4 the gun handle push-pull, it will form a vacuum oil bottle, oil bottle down the hose into the. (if the above operation, a gun trip, smoke less than the required amount of oil, to loosen the cover rubber sleeve of the thumb, push forward the oil gun handle again, and then repeat the pumping operation)
5 of the oil pump to the oil mark, do not make clear smoke filled with oil.
6 from the oil gun joint unscrew the bottle, mounted on the cover, pay attention to keep clean. External impurities. Then tighten the outer cover, the bottle cap to tighten tightly
7 finally, wipe off the hose end with a clean cloth or paper. Unscrew the round nut and pull the hose out of the nut. After each pumping, replace the new hose