Hebei Jimeng high-pressure pipe group limited, the registered capital of 50 million 980 thousand yuan, covers an area of 135 thousand square meters, is located in the "Chinese elbow pipe are the" Mengcun Autonomous County, specializing in the production of flanges, pipe fittings, elbow, three links, fittings, flange gasket and seal, is one of the domestic production of flanges, pipe components, series the earlier products manufacturers, the company has a quality inspection center, using the GB/T19001/2000 standard, through the national quality supervision and inspection and Quarantine Organization issued the acceptance of pressure pipe fittings, special equipment manufacturing license.
When we in the bigger diameter flange, long-term will show the drip, this will affect our use of large diameter flange, it will waste our capital, so that the user is the loss of contrast, about this question, we should how to deal with, here to introduce our flange plugging method:
All the fixtures must be written into the sealant. If the leakage points of the flanges are eliminated, if the other locality has the same doubt, the disposal will be more convenient. First we have to do is put on the fixture, walking on both sides of the leak and baffle, finally adjust the gap, according to the center of operation so that you can write a thorough treatment of flange sealant leakage of doubt.
There are many plugging methods of large diameter flange, noting that the number of each sector is not less than one injection hole, according to operation method and treatment center to sealant leak doubt. Our company's large caliber flanges do not usually have any questions. If there is any doubt, we can consult us and we will serve each customer.