High temperature sterilizing pot
High temperature sterilization pot is a sterilizing boiler, with the shutter type pressure vessel safety interlock device, independent electrical instrument control system, automatic constant temperature, heat preservation, timing, made of stainless steel material, has the advantages of beautiful appearance, health, safety, durability and other characteristics.
Product advantage
1 the equipment has the characteristics of double bath type sterilization pot, and 1 times higher than the double sterilization pot production, save energy and time, reduce the production cost for the user to save equipment investment and.
2 automatic switching the direction of flow, temperature uniformity without dead angle.
3 high temperature short time double pot cross sterilization, save time, save energy, save labor.
4 full automatic computer control, no manual operation.
The 5 film temperature regulating valve automatically adjust the temperature, sterilization and high accuracy.
6 measure F value function.
7 set up a variety of full-time sterilization formula.
Operation instructions
The general food factory for the packaging of the product for the normal pressure boiling water heating sterilization process are used in the form of horizontal sterilization pot, the introduction of compressed air through the device to achieve reverse pressure sterilization. Such as the cooling water in the pot, the pot must use the water pump into the top of the tube (or the water circulation system). When sterilization, the heated to a high temperature, the pressure in the bag over the bag (in pot) pressure. Therefore, in order to avoid sterilization packaging in the pressurization and damage, must exert anti pressure, which is compressed air through the increased pressure, prevent packaging damage, its operating conditions are as follows:
The compressed air is due to poor conductors, steam condition itself has a certain pressure, therefore, in the process of heating sterilization, do not put it in the compressed air, and is only in the face of the sterilization temperature after heat preservation, to open the compressed air into the pot, the pot increased by 0.15 ~ 0.2Mpa. After sterilization, cooling and cooling, stop the supply of air, cooling water into the water pipe. Because of the temperature drop, steam condensation, and the internal force is reduced by the pot of compressed air pressure compensation.
In the sterilization process, should pay attention to the initial exhaust, and then discouraged, so that the steam circulation. Can also be deflated once every 10 minutes to promote heat exchange. All provisions must meet the sterilization conditions, according to certain procedures, sterilization temperature, sterilization pressure, sterilization time and method of operation by the sterilization process of different products to make specific provisions