在你身边
What are the forms of insulation support..
Mrs.wu
Can you tell me whether the partition plate of the heat exchanger is single side welding o..
阳光boy
What is the value of the K value for the non circular flat cover calculation formula of GB..
gr888
What does the 15CrMo material need to pay special attention to during the flaw detection..
wangliang
On the pressure vessel, how can the brand of Hardy alloy be expressed..
海阔天空
Is the maximum allowable pressure of the standard flange greater than the working pressure..
TuKai
Excuse me, GB's nameplate, the design pressure is 3.5/FV MPa, the nameplate to show the va..
一路向东
What is the standard for full threaded bolts at the commodity level? The length is below 2..
啊呀呀
Ask, a pressure vessel is 273 tube, head cap can be used? A container is an upper class..
加油beyond
Excuse me, the non - standard B flange is not calculated according to the whole flange...