How can I mend the milling of the cylinder?

gr888

Hello, there is a jar, diameter 1000mm, there is no manhole, the design drawings on the ring seam is an inner gap, an outer groove, the head has been processed according to the corresponding groove,
When the cylinder is broken, the cylinder can be milled into the outer groove. How should this be handled?

2017-07-03 Reply

啊呀呀

1. re milling the wrong groove to see if there is a margin for the length of the cylinder
2. to see whether the head of the butt butt joint with the cylinder has a margin
3. in the welding time, as far as possible the gap between the weld point welding
4., again

2017-07-05 09:08:41 Reply